Perma Edge Installation Instructions
Better Product – Better Project.
No More Failed Edges!

Perma paver edging INSTALLATION ISTRUCTIONS

There are many disappointments with plastic edging. These disappointments eventually drove my quest for a solution! Perma Paver Edging has been engineered to serve as the industies solution to the traditional plastic and concrete edging. Perma Paver Edging is easy to install and can be applied to any shaped paver project. On the first day of install you will see the difference. Perma Pver Edging will create a bond with the pavers and limestone base that won’t allow soil or mulch to get in.

We formulated Perma Paver Edging using non-porous aggregates and add mixtures, to prevent cracking, sprawling and lifting. It settles with the pavers, not against them… Stop pounding spikes or using concrete that crumbles and Start Spreading PERMA PAVER EDGING!

STEP 1

Prepare the pavers to be edged. Break away the bedding layer, sand / chips.

STEP 2

Mix, use 1 gallon of water per 5 gallon bucket of Perma Paver Edging.

STEP 3

Using a scoop or flat shovel, distribute evenly along the pavers edge.

STEP 4

Using a 4" hand trowel, smooth Perma Paver Edging at approximately a 36 degree pitch and approximately 1/2" up on the bottom of the paver. Be sure to fill any voids from undermining prior to troweling.

STEP 5

Compact the pavers, while Perma Paver Edging is still wet.

STEP 6

Proceed with fine grading around the pavers using topsoil, mulch or stone.
Typical “hard scape” pavers
One (1)inch of typical paver bedding layer
A minimum depth & extended base of six (6)inch compacted paver base

Perma Paver Edging (installed above compacted paver base and surrounding the bedding layer)

Note: Local soil conditions impact depth. Guidelines for walkways & driveways vary. Consult your local dealer for guidance.